2011-02-01 Bible Explorations TV

IAUA

IAUA End Time Ministry

Preparing for the End of Time

The Lord is Coming!   Are you ready?

Home / Archives

I am so excited to be sitting here watching "Bible Explorations" TV (BETV) on my 3ABN satellite system. The undiluted truth is now available on the G19 satellite. This is the same satellite on which 3ABN is available. Anyone with a satellite system which receives 3ABN can also receive BETV. The Fourth Angel's Message and the Third Elijah Message are now enhancing the Three Angel's Message.

Details such as frequency, which has changed before, must be verified at the BETV (Bible Explorations) website. (These settings were updated 2015-08-01.)

This is what I did on my Topfield 6200 satellite receiver:

  1. Using your Topfield remote control push the "Menu" button.
  2. Press the down arrow to highlight "Installation".
  3. Press OK button.
  4. Press the up arrow to select "SAT/TP Edit".
  5. Press OK button again on "Satellite Name" (A box with a list of satellite names will pop up on the right hand side).
  6. Press the down arrow to select "Intel_Amer5(KU)" (Already selected!).
  7. Press OK button.
  8. Press the down arrow to select "Add new TP".
  9. Press OK button to display new window "Add New TP - "Frequency" will be highlighted in white.
  10. Using the number buttons on the remote control enter the numbers 12184.
  11. Press the down arrow to select "Symbol Rate".
  12. With the number buttons on the remote control enter the numbers 22000.
  13. Press the down arrow to select "Polarization" and push the the right arrow until it reads "Horizontal".
  14. Press the down arrow to the word "OK" and press the OK button on the remote control.
  15. Press the down arrow to select "Service Search" and press the OK button on the remote control.
  16. In the lower right hand corner you will see two bars, one says "Level" and one says "Quality". You should have a green "Level" bar
  17. Press the down arrow to select "Search Mode" then press the right arrow until it reads "Manual".
  18. Press the down arrow to select "FTA/Scrambled" and press the right arrow until it reads "FTA Only".
  19. Press the down arrow to select "Start Search".
  20. Press OK button and a "Searching" screen will appear.
  21. When Channel Scan is completed press OK, the Service Search Screen will appear.
  22. Press EXIT button to exit and view programming.

You will probably want to move channels around to where you want them, which is another complicated set of instructions unique to your receiver.

I can't possibly help you with the details of your system. Unless you feel confident of your skills with programming satellite receivers, or you have local assistance, you should not attempt this operation.

Next: 2011-02-04 Passover

Revised 2015-08-01